Genuine German HK manufactured claw mount. The HK claw mount works on all HK rifles and any clone with an in-spec receiver. Made clone receivers have incorrectly shaped scope mount tabs (Century for example) or incorrectly positioned rear sight bases make sure your clone is with in spec. No longer made or available as these are out of production and supplies are drying up worldwide. As you can see the mount is pretty sweet. Original deep green Mil spec paint has not been touched and if I had to guess on its age perhaps early 80’s. If it was used I would say minimal if any. I cleaned the mount in an ultrasonic bath as to preserve the original paint and lettering then thoroughly oiled all pivot points with Interflow high grade lubricant. The rings are custom made for this mount 4 screw so the scope will grip tight in the saddles. I included a picture with scope to give you the optics of how it all comes together pretty nicely. When you do see these mounts they are never advertised with rings. These mounts were originally intended for rail mounted scopes. That wasn’t an option for me. Too much clutter and unwanted height. These afford you the flexibility to run whatever scope you desire. They are CNC machined out of Anodized Billet and the extra step was taken in fitting a threaded 6mm Stainless insert at the base of the recoil lug as seen in the pictures. This feature gives you reliability and strength when torqueing down the rings to the mount. You owe it to yourself to own the best scope mounting set up period.